A rilru a hah lutuk chuan a rilru a buai em em a. PHD-12TP-111M

Hriselna hmuna input

Signal chi hrang hrang

1) wire thum PNP/NPN sensor input:
Sensor sem dan:(2+、15、3-):14V,
Tunah hian:
Input frequency: 0.1Hz~100kHz a ni

2) Frequency signal luh dan: 1.1.
Input frequency:0.1Hz~100kHz a ni
Input voltage phal zat sang ber: 30Vp-p
Input level tlem ber: 0.2V(2Hz~100kHz) a ni.
                                       2V(0.1Hz~100kHz) a ni.

3) Proximity switch, dry contact switch input: A chhuahna tur hmun leh a hmanna tur hmun:
Distribution voltage:(4+、5-)≈8V,Short-circuit current:(4+、5-)>7mA a ni
Input frequency :0.1Hz~100kHz a ni

Output chu hmun him takah a awm

A chhuahna signal a ni

0~20mA、4~20mA、0~5V、0~10V a ni

Tuna output load resistance a awm mek

Voltage chhuahna load resistance a awm

≥300Ω a ni

Parameter bulpui ber berte

Power supply a ni

20~35V DC a ni

Power hmanralna a ni

≤85mA(24V power supply, 20mA chhuahna) a ni.

Impulse zau zawng a ni

≥2μs a ni

Output dik tak a ni

0.1% FS a ni

Temperature a inthlak danglam thin

0.01% FS/°C a ni

Input signal fault detection function chungchang chipchiar zawka hriat duh chuan a hman tur manual en rawh

Relay-a chhanna hun hman

20ms a ni

Hnathawh dan lum leh vawt

-20°C~+60°C a ni

dahna hmun lum leh vawt

-40°C~+80°C a ni

Relative humidity a awm lo

10%~95%RH (condensation awm lo) a ni.

EMC a ni

GB/T 18268(IEC 61326-1) atanga a lan dan chuan

Insulation chakna a ni

Intrinsically safe side leh non-intrinsicallysafe side inkarah≥2500V AC/min
Power supply leh non-intrinsically safe side inkar ah ≥2500V AC/min

Insulation a do theih loh

≥100MΩ(input/output/power supply inkar) a ni.

Wire mamawh a ni

Cross-section ≥0.5mm2;Insualna chakna ≥500V

Installation hmun a ni

Safe zone-a dah a nih chuan Zone 0, IIC, Zone 20, leh IIIC thlenga hmun hlauhawma intrinsic safety instrument-te nen a inzawm thei a ni

Field hmanrua hman tur

DIN19234 NAMUR proximity switch, dry contact switch etc. field devices (intinsic pressure switch, temperature switch leh luquid level switch etc. te pawh tel) , level impulse signal, wire thum PNP/NPN sensor output, incremental encoder te a sawi dan chuan

Safety certification pek a ni

Puak thei lo chhinchhiahna

[Exia Ga] IIC [Exia atanga lo chhuak] IIIC

Puak thei lo standard a ni

GB/T 3836.1-2021, GB/T 3836.4-2021 te a ni

Terminal 4-5 thleng a awm

Um=250VAC/DC,Uo=10.5VDC,Io=14mA,
A rilru a buai em em a, a rilru a hah em em bawk a. Po=37mW,Co=2.4μF,Lo=165mH

Terminal 3-6 thleng a awm

Um=250VAC/DC,Uo=14VDC,Io=8mA,
Po=28mW,Co=0.73μF,Lo=150mH a ni

Terminal-ah 1-2-3 a ni

Um=250VAC/DC,Uo=17.5VDC,Io=330mA,
Po=1.4W,Co=0.375μF,Lo=0.22mH a ni

Certification siamtu pawl a ni

Shanghai-a Inspection leh Testing Institute of Instruments and Automation Systems (SITIIAS) chuan a sawi chhuak a, a hlawhtlinna chu a hlawhtlinna a ni.