- Terminal Board
- A dang tein chiahmi himnak khamnak
- Signal Isolators
- Surge kilvennak thilri
- Himnak Relays
- A dang tein chiahmi fimthiamnak I/O Modules
- Fimthiamnak Kutka
- Riantuannak Data Optical Transceivers
- Online Dew Point Analyzers
- Data laknak Modules
- HART data thlennak
PHD-11TF-28
A tlangpi in
Switch luhternak transistor chuahnak he a dang tein chiahmi himnak khamnak, cu nih cun ttihnung hmun ah switch pehtlaihnak asiloah a naihmi switch hna in himnak khamnak chungin chuahnak transistor he himnak hmun ah luhternak signal kha a thleidan i a kuat. Line palhnak hmuh khawhnak cu module cunglei ah LED hmangin tuah khawh a si. Module i dial switch cu in-phase asiloah hnulei uknak luhternak le chuahnak chiahnak caah hman a si, cun line palhnak hmuh khawhnak ralrin peknak riantuannak kha on le phih khawhnak caah hman a si.
* bus dinhnak mei peknak, a tawinak caah appendix zoh.
| A sining | |
| A ttihnungmi hmun ah luhternak | |
| Luhternak hmelchunhnak | Pehtlaihnak/naihniam thlennak thlennak |
| Sensor nih a chuahpimi thazaang | 8V hrawng |
| Thlennak rate | |
| Luhnak/chuahnak sining: | |
| Hmunhma ah luhtermi a tu | >2.1mA, chuahmi cu a khar, ON a langhter; |
| A thlenmi uknak le a ttha mi chuahmi karlak ah thlennak ec | Dial switch K1 cu "ON" ah a um tikah, transistor chuahmi ec cu aa merhmi dirhmun ah an um |
| Dial switch K1 cu "OFF" ah a um tikah, transistor chuahmi ec cu a ttha mi dirhmun ah an um | |
| K2 cu "ON", circut nih mei sen LFD langhternak ralrin peknak riantuannak kha a thim lai | |
| A himnak hmun ah chuah | |
| Chuahmi signal | Relay le ralrin peknak relay (duhthimnak) |
| Chuahmi sining | NPN phun transistor chuahtertu asiloah khontu onmi circuit chuahmi |
| Mawtaw mawngh khawhnak | A chuakmi current ≤ 20mA (1.2k Ω), a sangbik chunglei current 100mA, short-circuit current kilvennak he aa thuam |
| A hrampi parameters | |
| Supply voltage | 20~35VDC |
| Thazaang hmannak | |
| LED hmelchunhnak | A sen: Thazaang langhtertu |
| A sen: A ttha tein rian a ttuan lio ah a chuakmi transistor | |
| Sen: LFD langhternak, line palhnak ralrin peknak | |
| Khuacaan tahfung | Riantuannak lumnak: -20°C ~ +60°C, |
| Chiahnak lumnak: -40°C ~ +80°C | |
| Aa pehtlaimi lumternak | 10%~95% RH ah ti a luang lo |
| Insulation thazaang | A chunglei in a himmi lei le a him lomi lei karlak (≥3000VAC/min); thazaang peknak le a him lomi lei (≥1500VAC/min) karlak ah |
| Insulation doh khawhnak | ≥100MΩ (luhnak/chuahnak/mei thazaang peknak karlak) |
| Electromagnetic aa tlaknak | IEC 61326-1 (GB/T 18268) ning in, IEC 61326-3-1 |
| MTBF | 100000h |
| Wire herhmi | A tthennak ≥ 0.5mm2; Hrialnak thazaang ≥ 500V |
| Hman khawhmi lo thilri hna | DIN19234 phunglam he aa tlakmi a ro cangmi pehtlaihnak asiloah NAMUR phun naihnak thlennak luhternak tibantuk loram thilri hna |
| Chiahnak hmun | A himnak hmun ah chiah ahcun, Zone 0, IIC, Zone 20, le IIIC tiang tihnung hmun ah a chunglei himnak thilri hna he pehtlaih khawh a si |
| A chunglei in a himmi hngalhternak | |
| Puah khawh lonak hmelchunhnak | [Ex ia Ga]lIC [Ex ia Da]lllC |
| Puak kho lomi phunglam | GB/T3836.1-2021 GB/T3836.4-2021 |
| Terminal 3-4 | Um:250V AC/DC Uo=10.5V DC lo=15mA |
| Po=39.4mW Co=1.7μF Lo=165mH | |
| Fehternak bu | CQST(Tuluk Ram puahnak in a himmi electric thilri hna caah tthatnak zohkhenhnak le hneksaknak hmun) |
Line palhnak hmuh khawhnak (LFD)
Hmantu hna nih module cunglei ah "ON" lei kha an thim khawh palhnak hmuh khawhnak riantuannak kha tuah khawh awk le ralrinnak langhter awkah LED ceunak sen. Hmun ah luhternak current>7mA, short circuit alarm (SC);
Hmun ah luhternak current pehtlaihnak luhternak nih palhnak hmuh khawhnak rian a herh (hri a kiak, a tawi circuit), 22k Ω resistor cu a donghnak pahnih ah aa tluk tein pehtlaih a si lai thlennak, le a 680 Ω resistor cu a hnu hnu in pehtlaih ding a si (as switch pehtlaihnak II caah hri suaimi ah langhter a si).
