Digital luhternak
- Terminal Board
- A dang tein chiahmi himnak khamnak
- Signal Isolators
- Surge kilvennak thilri
- Himnak Relays
- A dang tein chiahmi fimthiamnak I/O Modules
- Fimthiamnak Kutka
- Riantuannak Data Optical Transceivers
- Online Dew Point Analyzers
- Data laknak Modules
- HART data thlennak
PHD-11TF-28+
A tlangpi in
Switch luhternak transistor chuahnak i a tthawnnak kilvennak riantuannak he a dang tein chiahmi himnak khamnak, cu nih cun ttihnung hmun ah switch pehtlaihnak asiloah a naihnak switch hna in himnak khamnak hmun ah himnak khamnak chungin chuahnak transistor he himnak hmun ah luhternak signal kha a thleidan i a kuat. Line palhnak hmuh khawhnak cu module cunglei ah LED hmangin tuah khawh a si. Module i dial switch cu in-phase asiloah hnulei uknak luhternak le chuahnak chiahnak caah hman a si, cun line palhnak hmuh khawhnak ralrin peknak riantuannak kha on le phih khawhnak caah hman a si. Hi thilri nih hin a dang tein mei a herh, a dang tein mei a herh, luhternak le chuahnak terminal hna he.
| Tihnung hmun ah luhternak | |
| Luhternak hmelchunhnak | Pehtlaihnak/naihniam thlennak thlennak |
| Sensor nih a chuahpimi thazaang | 8V hrawng |
| Luhtermi frequency tlukruannak | ≤5kHz |
| Luhnak/chuahnak sining: | |
| Hmunhma ah luhtermi a tu | >2.1mA, chuahmi cu a khar, ON a langhter; |
| A thlenmi uknak le a ttha mi chuahmi karlak ah thlennak ec | Dial switch K1 cu "ON" ah a um tikah, transistor chuahnak ec cu a hnulei ah a um Dial switch K1 cu "OFF" ah a um tikah, transistor chuahnak ec cu a ttha mi dirhmun ah a um K2 cu "ON" ah a um tikah, circut nih mei sen LFD langhternak ralrin peknak riantuannak kha a thim lai |
| Chuahmi | |
| Chuahmi signal | Transistor le alarm relay (na duh ahcun) |
| Mawtaw mawngh khawhnak | A chuakmi current ≤20mA (1.2kΩ), chunglei a tam bik 100mA, short-circuit current kilvennak he aa thuam |
| Surge kilvennak thilri hna: | |
| Nominal discharge current ln(8/20μs) | 5kA |
| Voltage kilvennak tlukruannak cunglei(8/20μs): | 60V(line in line) |
| Voltage kilvennak tlukruannak cunglei(8/20μs): | 600V(line in vawlei) |
| Phunglam ning in | GB/T18802.21-2016(1EC61643-21:2012 he aa tluk) |
| A hrampi parameters | |
| Supply voltage | 20~35VDC |
| Thazaang hmannak | |
| LED hmelchunhnak | A sen: Thazaang langhtertu A sen: A chuakmi transistor cu a ttha tein rian a ttuanmi a si A sen: LFD hmelchunhnak, line palhnak ralrin peknak |
| Khuacaan tahfung | Riantuannak lumnak: -20°C ~ +60°C, Chiahnak lumnak: -40°C ~ +80°C |
| Aa pehtlaimi lumternak | 10%~95% RH ah ti a luang lo |
| Insulation thazaang | A chunglei in a himmi lei le a him lomi lei karlak (≥3000VAC/min); thazaang peknak le a him lomi lei (≥1500VAC/min) karlak ah |
| Insulation doh khawhnak | ≥100MΩ (luhnak/chuahnak/mei thazaang peknak karlak) |
| Electromagnetic aa tlaknak | GB/T 18268 (IEC 61326-1) |
| MTBF | 80000h |
| Wire herhmi | A tthennak ≥ 0.5mm2; Hrialnak thazaang ≥ 500V |
| Hman khawhmi lo thilri hna | DIN19234 phunglam he aa tlakmi a ro cangmi pehtlaihnak asiloah NAMUR phun naihnak thlennak luhternak tibantuk loram thilri hna |
Bialehnak: Power rail i power supply cu thim khawhmi riantuannak a si.
Hmantu hna nih order an tuah tikah power supply mode kha an langhter a hau.
Cahmai 89 i aa pehtlaimi kha zoh.
Line palhnak hmuh khawhnak (LFD)
Hmantu hna nih module cunglei ah "ON" lei kha an thim khawh
palhnak hmuh khawhnak riantuannak kha tuah khawh awk le ralrinnak langhter awkah
LED ceunak sen. Hmun ah luhternak current>7mA, short circuit alarm (SC);
Hmun ah luhternak current
pehtlaihnak luhternak nih palhnak hmuh khawhnak rian a herh (hri a kiak, a tawi
circuit), 22k Ω resistor cu a donghnak pahnih ah aa tluk tein pehtlaih a si lai
switch, le 680 Ω resistor cu a hnu hnu in pehtlaih a si lai (as
switch pehtlaihnak II caah hri suaimi ah langhter a si).
PHD-11TC-33A-23
PHD-11TF-28+